![]() Can automatically copy existing Wi-Fi settings from Fios Quantum Gateway for plug-and-play setup.Can use coax to connect to gateway router for homes not wired with Ethernet. ![]() As discussed previously, the primary advantage of the FNE are: Note that if Ethernet backhaul works for you at all, then you don’t need the Fios Network Extender – because most modern routers support AP mode. All of this may be obvious to a computer networks expert, it will not be intuitive to an average Fios customer that the Ethernet ports can be used for client devices as well as backhaul without correct labeling and/or better written manuals. ![]() The description above is not entirely accurate, either, because the Ethernet ports can be used to connect client devices. One way to get around this issue is to reduce the number of channel bounding on your goCoax 2.5, but that setup is complicated and cannot be guaranteed to work 100 of the time. The setup section never mentioned how to connect the Extender to a gateway router via Ethernet. WCB6200Q with Verizon firmware does not work well with MoCA 2.5 devices. A few days ago I changed the password to a set of diceware words. The SSID on the extender is 'abcx' for both 2.4 and 5Ghz. The SSID on the gateway router is 'abc' for both 2.4 and 5Ghz. While the description section reads:ĭual-port Gigabit Ethernet switch: used for directly connecting the Actiontec WCB6200Q Extender cannot connect to 5G. The confusion probably originates from the badly written Actiontec User Guide for WCB6200Q. I have verified that the Ethernet port #1 can be used for backhaul to the gateway router. FAQ Can I use the Ethernet ports to connect the Extender to the gateway/modem?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |